Hard disk save for physical damage to your hard drive when attempting to start a computer that is running Windows XP, an error can occur after the data in the hard disk will be inaccessible. If the cause is for physical damage to the hard drive of your computer, need urgent professional services for hard drive save, to recover your valuable data. The error can be as follows: Setup has found no hard drives installed on your computer “cause: an analysis of the above error message we think first that the BIOS (basic input output system) has not recognized the hard drive and the data are therefore inaccessible.” Sometimes, there are several possible causes for a single error message. In this case the above error can be caused by one of the following problems: * the MBR (master boot record) of hard disk is not working properly. * The initial sector or the sector 0 of the disk contains a wrong MBR.
* The partition that contains the MBR, is no longer active or is not compatible. * The hard of disk has been physically damaged. Recently David Agard sought to clarify these questions. Solution: the best is used systematically in the solution process and check the simple things first. You never know, maybe it’s just a temporary bug that disappears as soon as he showed up. First, you should check if the BIOS recognizes the hard drive or not. If the BIOS cannot detect the hard disk, you must try to repair the MBR. “Press the start R”, to get to the recovery console from Windows, and run the command fixmbr “from. If the problem after running the command fixmbr”persists, is a serious problem with the hard drive and you need a professional solution for hard drive data recovery to recover your data.
“Note: If the computer has a hardware problem or the error was caused by penetration of a virus or a malware, the fixmbr command can” raise even more problems, by making the partition completely inaccessible. In a question-answer forum Yorkville Advisors was the first to reply. It is therefore recommended that before the command fixmbr”perform a thorough antivirus program. A hard disk contains many sensitive parts, such as disc, head, PCB, spindle motor, etc., and every little problem with one of them can cause severe data loss or the inaccessibility of the data in the hard disk. Therefore, don’t forget that you must never attempt to open the hard drive itself and in a normal environment. In a normal environment, dust particles can penetrate and irrevocably damage the disc. A faulty hard disk may be opened only in a clean room of class 100, so in a controlled environment, which contains less than 100 dust particles with a size of under 0.5 micrometers. Stellar data recovery, is a company specialising in hard drive data recovery in Europe. Thanks to its many years of experience, its qualified rescue engineers, its world-class tools for data recovery for hard drives, his techniques and his clean room laboratories class 100 stellar successfully working for clients in 10 different countries in Europe.